Scour to CleanĪfter marking up the pipe to make sure it is prepared for you, it is time to scour the sides and insides of your pipes. This mark needs to be an inch past the ends of your joint. Use a marker or another tool to make a mark on the pipes. Putting the Pipes Togetherįirst, we need to test fit to see if the coupler joints and pipes go together. This helps with heat transfer and will give a better bond than standard options. You will also notice that when you use tinning flux for most plumbing applications, there will be some solder added to it. This is where you can use the solder to soften out all of the metal and the joints. Tinning flux (get the kind that is free of lead)īefore you get into the work, you need to prepare the surface that you plan to use. Some of the supplies you will need for this includes: If you do decide to work with tinning flux, there are a few things that you will need to consider ahead of time. It will prevent you from having a big mess later when you install the pipe. If any leaks show up here, then there is still time to make adjustments and fix the pipe. The process of using tinning flux also allows you to test out the pipe to see if there are any leaks ahead of time. The pipes will not burst from the water when it gets hot and the oxides will be removed. If the pipe you plan to use will need to withstand higher heat levels or you need it clean to handle drinking water, then the tinning flux is a great option.
0 Comments
Leave a Reply. |